20:00

PDF|

Guide for Advanced Design VMware NSX-T Data Center

Quiz Advanced Design VMware NSX-T Data Center

Free Test
/ 10

Quiz

1/10
Which is a family of solutions for data center designs that span compute, storage, networking, and
management, serving as a blueprint for a customer’s Software Defined Data Center (SDDC)
implementations? (Choose the best answer.)
Select the answer
1 correct answer
A.
VMware SDDC Design
B.
VMware Validated Design
C.
VMware POC Design
D.
VMware Cloud Foundation

Quiz

2/10
Which three IPv6 features are supported in an NSX-T Data Center design? (Choose three.)
Select the answer
3 correct answers
A.
IPv6 OSPF
B.
IPv6 static routing
C.
IPv6 switch security
D.
IPv6 DNS
E.
IPv6 Distributed Firewall
F.
IPv6 VXLAN
Reference: https://blogs.vmware.com/networkvirtualization/2019/02/ipv6-support-in-nsx-t-2-
4.html/

Quiz

3/10
An architect is helping an organization with the Physical Design of an NSX-T Data Center solution.
This information was gathered during a workshop:
Some workloads should be moved to a Cloud Provider.
Extend network’s VLAN or VNI across sites on the same broadcast domain.
Enable VM mobility use cases such as migration and disaster recovery without IP address changes.
Support 1500 byte MTU between sites.
Which selection should the architect include in their design? (Choose the best answer.)
Select the answer
1 correct answer
A.
Load Balancer
B.
Reflexive NAT
C.
SSL VPN
D.
L2 VPN

Quiz

4/10
An architect is helping an organization with the Physical Design of an NSX-T Data Center solution.
This information was gathered during a workshop:
There are six hosts and hardware has already been purchased.
Customer is planning a collapsed Management/Edge/Compute cluster.
Each host has two 10Gb NICs connected to a pair of switches.
There should be no single point of failure in any proposed design.
Which virtual switch design should the architect recommend to the organization? (Choose the best
answer.)
Select the answer
1 correct answer
A.
Create a vSphere Distributed Switch (vDS) for Management VMkernel traffic and assign one NIC.
Also, create an NSX-T Virtual Distributed Switch (N-VDS) for overlay traffic and assign one NIC.
B.
Create an NSX-T Virtual Distributed Switch (N-VDS) for Management VMkernel traffic and assign
one NIC. Also, create an NSX-T Virtual Distributed Switch (N-VDS) for overlay traffic and assign one
NIC.
C.
Create an NSX-T Virtual Distributed Switch (N-VDS) for Management VMKernel and overlay traffic
and assign both NICs.
D.
Create an NSX-T Virtual Distributed Switch (N-VDS) for Management VMkernel and overlay traffic
and assign a new virtual NIC.

Quiz

5/10
What selection is the key design benefit provided by a dedicated Edge Cluster VM or Bare Metal?
(Choose the best answer.)
Select the answer
1 correct answer
A.
reduced administrative overhead
B.
predictable network performance
C.
multiple Tier-0 gateways per Edge Node Cluster
D.
support for Edge Node Clusters with more than 10 Edge Nodes

Quiz

6/10
An architect is helping an organization with the Logical Design of an NSX-T Data Center solution.
This information was gathered during the Assessment Phase:





There is a performance based SLA for East – West traffic.
The business critical applications require prioritization of their traffic.
One of the services is a file share and has a high demand for bandwidth.
Which selection should the architect include in their design? (Choose the best answer.)
Select the answer
1 correct answer
A.
Review average North/South traffic from the core switches and firewall.
B.
Include a segment QoS profile and review the impact of utilizing this feature.
C.
Meet with the organization’s application team to get additional information.
D.
Monitor East-West traffic throughout normal business cycles.

Quiz

7/10
Which NSX-T feature is used to allocate the network bandwidth to business-critical applications and
to resolve situations where several types of traffic compete for common resources? (Choose the best
answer.)
Select the answer
1 correct answer
A.
Network I/O Control Profiles
B.
LLDP Profile
C.
LAG Uplink Profile
D.
Transport Node Profiles
Reference: https://docs.vmware.com/en/VMware-NSX-T-Data-Center/2.4/installation/GUID-
9A8FD62A-F099- 4329-8220-6D5853F9A62D.html

Quiz

8/10
An architect is helping an organization with the Logical Design of an NSX-T Data Center solution.
This information was gathered during the Assessment Phase:
Customer currently has a single 10 host vSphere cluster.
Customer wants to improve network security and automation.
Current cluster utilization and business policies prevent changing the existing vSphere deployment.
High-availability is important to the customer.
Which three selections should the architect include in their design? (Choose three.)
Select the answer
3 correct answers
A.
Apply vSphere DRS VM-Host anti-affinity rules to the virtual machines of the NSX-T Edge cluster.
B.
Deploy at least two NSX-T Edge virtual machines in the vSphere cluster.
C.
Deploy the NSX Controllers in the management cluster.
D.
Apply vSphere Distributed Resource Scheduler (vSphere DRS) VM-Host anti-affinity rules to NSX
Managers.
E.
Remove 2 hosts from the cluster and create a new edge cluster.
F.
Remove vSphere DRS VM-Host affinity rules to the NSX-T Controller VMs.

Quiz

9/10
An architect is helping an organization with the Conceptual Design of an NSX-T Data Center solution.
This information was gathered by the architect during the Discover Task of the Enagagement
Lifecycle:
There are applications which use IPv6 addressing.
Network administrators are not familiar with NSX-T Data Center solutions.
Hosts can only be configured with two physical NICs.
There is an existing management cluster to deploy the NSX-T components.
Dynamic routing should be configured between the physical and virtual network.
There is a storage array available to deploy NSX-T components.
Which constraint was documented by the architect? (Choose the best answer.)
Select the answer
1 correct answer
A.
Dynamic routing should be configured between the physical and virtual network.
B.
There are applications which use IPv6 addressing.
C.
Hosts can only be configured with two physical NICs.
D.
There are enough CPU and memory resources in the existing management cluster.

Quiz

10/10
Which two benefits can be achieved using in-band management of an NSX Bare Metal Edge Node?
(Choose two.)
Select the answer
2 correct answers
A.
Reduces storage requirements.
B.
Reduces cost.
C.
Preserves packet locality.
D.
Reduces egress data.
E.
Preserves switchports.
Looking for more questions?Buy now

Advanced Design VMware NSX-T Data Center Practice test unlocks all online simulator questions

Thank you for choosing the free version of the Advanced Design VMware NSX-T Data Center practice test! Further deepen your knowledge on VMware Simulator; by unlocking the full version of our Advanced Design VMware NSX-T Data Center Simulator you will be able to take tests with over 57 constantly updated questions and easily pass your exam. 98% of people pass the exam in the first attempt after preparing with our 57 questions.

BUY NOW

What to expect from our Advanced Design VMware NSX-T Data Center practice tests and how to prepare for any exam?

The Advanced Design VMware NSX-T Data Center Simulator Practice Tests are part of the VMware Database and are the best way to prepare for any Advanced Design VMware NSX-T Data Center exam. The Advanced Design VMware NSX-T Data Center practice tests consist of 57 questions and are written by experts to help you and prepare you to pass the exam on the first attempt. The Advanced Design VMware NSX-T Data Center database includes questions from previous and other exams, which means you will be able to practice simulating past and future questions. Preparation with Advanced Design VMware NSX-T Data Center Simulator will also give you an idea of the time it will take to complete each section of the Advanced Design VMware NSX-T Data Center practice test . It is important to note that the Advanced Design VMware NSX-T Data Center Simulator does not replace the classic Advanced Design VMware NSX-T Data Center study guides; however, the Simulator provides valuable insights into what to expect and how much work needs to be done to prepare for the Advanced Design VMware NSX-T Data Center exam.

BUY NOW

Advanced Design VMware NSX-T Data Center Practice test therefore represents an excellent tool to prepare for the actual exam together with our VMware practice test . Our Advanced Design VMware NSX-T Data Center Simulator will help you assess your level of preparation and understand your strengths and weaknesses. Below you can read all the quizzes you will find in our Advanced Design VMware NSX-T Data Center Simulator and how our unique Advanced Design VMware NSX-T Data Center Database made up of real questions:

Info quiz:

  • Quiz name:Advanced Design VMware NSX-T Data Center
  • Total number of questions:57
  • Number of questions for the test:50
  • Pass score:80%

You can prepare for the Advanced Design VMware NSX-T Data Center exams with our mobile app. It is very easy to use and even works offline in case of network failure, with all the functions you need to study and practice with our Advanced Design VMware NSX-T Data Center Simulator.

Use our Mobile App, available for both Android and iOS devices, with our Advanced Design VMware NSX-T Data Center Simulator . You can use it anywhere and always remember that our mobile app is free and available on all stores.

Our Mobile App contains all Advanced Design VMware NSX-T Data Center practice tests which consist of 57 questions and also provide study material to pass the final Advanced Design VMware NSX-T Data Center exam with guaranteed success. Our Advanced Design VMware NSX-T Data Center database contain hundreds of questions and VMware Tests related to Advanced Design VMware NSX-T Data Center Exam. This way you can practice anywhere you want, even offline without the internet.

BUY NOW